B&B Custom Sailtrack

B&B is pleased to offer a new custom sailtrack suitable for all sailboats small and large. This track has been designed by B&B and produced in the USA. Our goal with this track was to offer a high quality sail track at a competitive price that could be easily attached to round or rectangular mast sections. (At right: new track, left next to traditional track, right).


  • 6061-T6 Aluminum.
  • Satin 201 R1 Anodized.
  • Predrilled and countersunk holes for 532 countersunk rivets.
  • “Vee” groove for easy drilling.
  • 8 foot lengths.
  • For use with 5/8″ internal slides.

New track (left) old track (right)

The New Internal Aluminum Track: Our sail track is extruded aluminum and every corner inside and out is rounded. A concave back face with “feet” on either side fits perfectly on round mast sections down to 1.5″ diameter. The concave causes the track to literally “snap” into place and self aligns lengthwise on the mast. In larger diameters, the “feet” contact the surface to provide a wide contact area that cannot work loose over time.

Fastening: B&B sailtrack is pre-drilled and countersunk for 5/32 countersunk head rivets. We supply and recommend the use of  stainless steel rivets for our sailtrack. Stainless rivets should always be used when riveting aluminum in marine environments. As shown above, a small bushing is needed to extend the tip on a standard rivet gun in order to reach the rivet head due to the depth of the track. This can easily be made from a mild steel bolt on a drill press or in a pinch, a few #6 nuts can be stacked to act as a bushing.

For wooden masts, #8 screws can be used but will require a larger countersink in order for the screw to fit flush. A regular countersink can be ground down on a drill press with an angle grinder such that it fits between the sides of the track. Click here for an album of pictures showing our shop-made countersink which was used in testing.

Plastic Sail Slides: The track is designed for standard 5/8″ internal plastic sail slides. The combination of plastic sail slides on aluminum is superior to stainless on stainless which requires careful polishing and waxing to achieve friction free hoisting and lowering. Plastic slides can also be “hollowed” slightly on a belt sander to reduce friction on the backsides of the sail slides. Pictures of a hollowed slide can be seen in link above.

We are pleased to offer our sail-track at a price that will reduce the cost of our boat kits for our builders while at the same time improving performance.

Cost: $35.00 per 8′ length

Please call for wholesale pricing if you would like to distribute B&B sail-track.