Rudder

Tiller Clutch

We are happy to partner with Pete at Wavefront the developer of the one and only TILLER CLUTCH. We love the tiller clutch for all our small boats. It has the best action of any tiller holding system and uses only the highest quality materials. For larger...

Tiller extension swivel

Swiveling tiller extension hardware. Fits 3/4" diam tube. A tiller extension is very necessary on a sailboat. Without one the capitain is a slave to the back of the boat. With one you can lean forward, lean backward, hike out, or stand up while driving...

Rudder hold down

Small swiveling rudder hold down. Installed above the top pintle when the rudder is on the boat. It prevents the rudder from lifting out of the gudgeons during a grounding or in the event of a capsize.  Install with a little blob of silicone or a...

Tiller extension clip

This white plastic clip keeps your tiller extension in place. Fits perfectly on 3/4" diameter.

RL-358 Rudder Gudgeon

Light duty rudder fitting for use with RL 358 Pintle. Made from 5/8" wide by .060" thick stainless steel. Fits a 5/16" diameter pin. Total length is 4". Takes #10 fasteners. This gudgeon is used with all of our Designs under 15' feet such as the...

RL-358 (wide) Rudder Pintle

This pintle is designed to be used with Racelite #358 Gudgeons. Made from 5/8" wide by .060" thick stainless steel. Fits a 1 1/4" wide rudder but is easily bent wider or narrower to fit rudders between 3/4" wide up to 1 3/4" as is the case for the...

Small Rudder Hardware Kit

This kit contains all the hardware necessary for our smaller boats such as the Spindrifts and catspaw designs. -Racelite 358 Gudgeons and Pintles-Racelite 337 Rudder hold down clip-Ronstan 1127 Tiller Swivel-Ronstan 43E Tiller Extension...